concrete sealing Wollongong, line marking Wollongong
Does your concrete surface have cracks or pores that are a threat to your structure? If yes, then the way to seal the cracks and pores is by using concrete sealers. This is the best method to ensure that your structure does not get damaged. Concrete sealing services available in Wollongong are the best. All the steps for sealing are taken into consideration.
Furthermore, line marking is also something that must be done, be it in car parking, roads, etc. This technique will help reduce confusion on roads or where cars are to be packed. Each driver will know where the lane is and follow it.
First stage
The stage is carried out manually or using additional devices that are included in the set of marking machines. The marking place is protected from the movement of other modes of transport. The main control points are determined based on the location of which the line markings will be applied. They are calculated using a curvimeter and recorded with chalk marks. Subsequently, they will be applied for preliminary marking.
Coating preparation
The second stage is the preparation of the place where line marking will be done. The place must be free of dirt and dust. For this purpose, use a washing machine or a machine with a brush and a blower.
The area should be dry and also be clean before proceeding to the main process. It is allowed to use injection gas-air burners.
If there is an old marking on the area that is subject to change or if its thickness is more than 6 millimeters, then it should be removed first. Also, the old marking is subject to removal if there is a danger of its peeling along with the new one.
Unsuitable markings can be removed in several ways; mechanically (special mechanisms are used that remove the old markings and, if necessary, cut asphalt up to two millimeters thick), hydraulically (old markings are washed off under the pressure of the water)
Security
For the line markings to be applied evenly and not to be spoiled by vehicles moving along the road, special barriers and signs are used. They are installed at the marking points and remain there until the markings completely dry.
The center lines are painted first. The remaining lines of the road marking are parallel to it and therefore are applied by a marking machine with a telescopic bracket.
For applying road markings, only special paints and plastics that meet the requirements of GOST are used. Paint is applied only at a certain temperature and humidity. These data are indicated in the instructions for its use. The average temperature for applying paint should not be less than 15 degrees, and humidity should not exceed 85%.
Paints, consisting of one component, are applied only to a cleaned and dry surface, for more reliable fixation and speedy drying. For proper application of paint for road marking, it is recommended to use equipment that matches the paint used.
Line markings are applied pneumatically or hydraulically. Opt for line marking services in Wollongong and keep your packing place organized.