How do you put on frontal lace wig?
There are many ways you can put on your frontal lace wig. You can put it on with either tape, elastic bands, or glue. If you decide using glue, ensure to use the correct adhesive type that is specifically designed for the installation of the lace front wigs. Avoid using the lash glue or the usual one that handles craftwork. Before deciding to put on the wig, ensure to test your skin for allergies in regards to the materials that you may intend to use. You can hack this by dabbing little amount of the glue, the tapes on the back of your hand, and observe whether you will encounter any changes. If there is none, you will be good to proceed.
How to wear frontal lace wig without glue
This can be done through installing the frontal lace wig the use of the adhesive glue following the below few steps:
- To begin with, prepare your skin. Wash it gently with a cleanser and dab some alcohol on a cotton bud to ensure you wipe out all the excessive oils.
- Braid your hair into cornrows to make your hair flat, which helps in keeping the wig into its place. Also, it helps to ensure all your hair is tacked into the wig cap on all sides.
- Check if the wig fits you by placing it in your head and in all sides alongside the hairline to make it fit properly. Ensure to adjust it to the best suitable position using the elastic bands.
- Once you are sure that the wig fits appropriately, then trim the excessive laces of the wig.
- For the wigs that are not unplucked, ensure to pluck them by the use of tweezers, then make your natural hairline to match your skin tone.
- If you need to create baby hair, cut some strands of the hair from your hairline and pull them out such that they bring forth a natural look. Use water to lay the edges.
- Then tie a scarf around the edges and allow it to remain that for some time and remove.
- Finally, style your hair the way you desire.
Wear the frontal lace wig using glue
- Braid cornrows, to secure and flatten your hair inside the wig cap
- Put on the wig to check whether it fits. Ensure to align it with the natural hairline.
- Remove the Wigand apply glue using a brush along the hairline and blow-dry it. Do another layer using the same process until it is tacky and clear. Then install your wig. After that apply freeze spray to ensure the wig stays in place
- Adjust the wig edges to have a natural-looking hairline. Avoid pressing the laces of the edge of the wig as it may become difficult to remove it.
- With the use of the foundation-brush, apply concealer until it blends the knots to your skin color for a more natural look.
- You can finally comb your hair and style it in your desired way.
Note, when removing the frontal lace wig, ensure to use adhesive remove, which helps in softening the glue to make the work easier.